Kaiju Video Smasher – Software Dev 1

Posted on by

With the general idea for the patch decided and the sub components outlines, it’s time to start patching.

Starting the project. I have all the hardware I think I’ll need with me.

  • A flex sensor
  • My arduino with protoboard and prototype shield
  • Access to an old ECE kit full of resistors and such
After doing some quick google searching for flex sensor and found this handy site: http://itp.nyu.edu/physcomp/sensors/Reports/Flex
It has a ton of good info about the use of a flex sensor and some interesting amplifier schematics for filtering the output of the sensor. Since I don’t have access to an opamp, I’ll keep looking for an easier circuit to interface with my arduino.

From the product page at sparkfun [http://www.sparkfun.com/products/8606] I got a hold of the sensor’s data sheet and with that applied the flat and flexed resistance values to some voltage divider equations I found on this site [http://protolab.pbworks.com/w/page/19403657/TutorialSensorsscroll down a bit] to calculate the voltages that arduino will measure when the sensor is flat and when it is flexed. I just guessed the 1k ohm resistor value, but after chugging through the voltage divider equation, I’ll get around 2.1 volts difference between flat and flexed. That should suffice.

I cobbled together the circuit defined at the site above so I can start working with the arduino. Here’s my fritzing layout:

Taking the  voltage divider setup and the AnalogInSerialOut sample sketch in the arduino software I have been able to see how the voltage signal from the flex sensor changes as it’s manipulated. Over the entire range of safe flexibility, the digital values reported from the arduino had a value range from 150 to 600. Since I want a range from 0 to 1024, I’ll remap the values using map() and then send them out as a formatted serial string.

For outputting, my method is super-simple just take the value and print it using Serial.print() in a set format. My printing code is as follows:

  Serial.print(' '); // lead with a space
  Serial.print('F'); // print out value label
  Serial.print(' '); //another space
  Serial.print(outputValue); // the int flex value
  Serial.print(' '); // wow, another space
  Serial.print('r'); // "newline"

The code above ends up printing out things like ” F 730 ” which can be easily parsed in pure data which is what I’m going to work on next.

Leave a Reply